Table of Contents
Advertisement
Troubleshooting
Checkpoints
If you encounter a problem with the washer, first check the table below and try the
suggestions.
Problem
Does not turn on.
Does not start.
Water is not supplied.
After a cycle, detergent
remains in the
automatic dispenser.
56 English
Make sure your home electrical system is providing electrical
•
power that matches the requirements of the washer. See page 19.
•
Make sure the power cord is completely plugged in.
•
Check the fuse or reset the circuit breaker.
Make sure the door is closed.
•
•
Make sure the water taps are open.
•
Make sure to press or tap START/PAUSE to start the washing
machine.
•
Make sure Child Lock is not activated.
•
Before the washing machine starts to fill, it will make a series of
clicking noises to check the door lock, and then does a quick drain.
•
Was the door opened during the spinning cycle? Close the door,
and then press or tap START/PAUSE to resume.
•
The machine enters Standby or is in a soaking cycle. Please wait.
Check the fuse or reset the circuit breaker
•
•
Make sure you press or tap START/PAUSE after selecting the cycle
and options.
•
Make sure the water taps are open.
Are the mesh filters in the water inlets clogged? Clean the mesh
•
filters by brushing with a toothbrush. See page 53.
•
Is the water supply cut off? If the water supply is cut off, close the
tap and power off.
•
Straighten the water supply hoses.
•
Open and close the door, and then press or tap START/PAUSE.
•
If the water pressure is low, it takes longer to start washing.
If the water level is not as high as necessary or lower than
•
expected, use the level selector to adjust the water level.
•
Make sure the washing machine is running with sufficient water
pressure.
Make sure the detergent drawer is properly inserted.
•
•
Remove and clean the detergent drawer, and then try again.
Action
Advertisement
Table of Contents
