Signal Setting - Siemens WT43H0L7DN Installation And Operating Instructions Manual

Signal setting

en
M
Signal setting
Y ou can change the following settings:
S i g n a l s e t t i n g
The speed at which the washing
■
machine was spun; only used if the
anticipated drying time needs to be
displayed more accurately,
The volume of the audible signal at
■
the end of the programme,
The volume of the audible button
■
signals.
You will need to activate the setting
mode in order to change these settings.
Activating setting mode
Switch the dryer on.
1.
Select the "Cottons" programme in
2.
position 1 and wait for 5 seconds.
Setting mode is now activated. The
symbols go out on the display panel
and the programme duration is
displayed.
Press and hold the Start button and,
1.
at the same time, turn the
programme selector clockwise to
position 2.
The spin speed is shown on the
2.
display.
Press the "Ready in" time button to
3.
change the spin speed.
Turn the programme selector
4.
clockwise to position 3.
28
The volume for the audible signal at
5.
the end of the programme is shown
on the display.
0 = off, 1 = quiet, 2 = medium,
3 = loud, 4 = very loud
Press the "Ready in" time button to
6.
change the volume.
Turn the programme selector
7.
clockwise to position 4.
The volume for the audible button
8.
signal is shown on the display.
0 = off, 1 = quiet, 2 = medium,
3 = loud, 4 = very loud
Press the "Ready in" time button to
9.
change the volume.
You can select other positions
Note:
with the programme selector; however,
you will be unable to change these
settings.
Exiting setting mode
Turn the programme selector to the
"Off" position once you have set the
required spin speed and the volume.
The settings have now been saved.