Preparation Before Operation - Mitsubishi Electric Mr. SLIM MSY-JS18VF Operating Instructions Manual

N
AME OF EACH PART
Remote controller
Signal transmitting section
Distance of signal : About 6 m
Beep(s) is (are) heard from the indoor unit when the signal is
received.
* Refer to page 15 for ERROR CODE DISPLAY MODE.
Operation
display section
OFF/ON (stop/
operate) button
Page 7
FAN speed
control button
Page 8
Operation
select button
Page 7
FAST
COOLING
button
Page 9
SLEEP
button
Page 9
VANE
control
button
Page 8
CHECK
button
Page 15
RESET
Lid
button
Slide down
Page 6
to open
Only use the remote
controller provided with
the unit.
Do not use other remote
controllers.
If two or more indoor units
are installed in proximity
to one another, an indoor
unit that is not intended to
be operated may respond
to the remote controller.
*
Battery
replacement
indicator
Page 6
Temperature
buttons
Page 7, 15
Off-timer
button
Page 10
On-timer
button
Page 10
TIME set buttons
Page 6, 10
forward button
backward
button
WIDE VANE
control
button
Page 8
CLOCK button
Page 6
Remote controller
holder
• Install the remote controller
holder in a place where
the signal can be received
by the indoor unit.
P
REPARATION
BEFORE OPERATION
Before operation: Insert the power supply plug into the
power outlet and/or turn the breaker on.
Installing the remote control-
ler batteries
4.
Press RESET.
1.
Remove the
front lid.
3.
Install the front lid.
Note:
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries and leaking batter-
ies. The remote controller could malfunction.
• Do not use rechargeable batteries.
• The battery replacement indicator lights up when
the battery is running low. In about 7 days after the
indicator starts lights up, the remote controller stops
working.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. How-
ever, batteries with expired shelf lives last shorter.
• Press RESET gently using a thin instrument.
If the RESET is not pressed, the remote controller
may not operate correctly.
Setting current time
1.
Press
CLOCK.
3.
Press CLOCK
again.
Note:
• Press CLOCK
gently using
a thin instru-
ment.
2.
Insert the
negative pole
of AAA alkaline
batteries fi rst.
2.
Press the TIME set
button to set the
time.
Each press
changes the clock
1 minute forward/
backward (10 min-
utes when pressed
longer).
En-6