Page 2
From all of us at Massimo Electric, Thank You for your purchase. This manual covers the main data, basic structure, and main procedures of operation, adjustment, maintenance and troubleshooting for your new E-Spider. It will help you familiarize yourself the vehicle for optimal operation, minimized issues, and a long service life.
RIDING SAFETY WARNING Vehicle riding requires special efforts on your part to ensure your safety. Know these requirements below before you fide. For on-road use, this vehicle is designed to be operated only on level, on –road surface, free of obstacles. Do not operate this vehicle while under the influence of alcohol or drags.
Page 5
SAFETY ADVISORY 1. Most vehicle accident fatalities are due to head injuries. Always wear a helmet. You should also wear a face shield and protective clothing. 2. Do not wear loose clothing that could catch on the control levers, footrests or other parts of the vehicle. REFITTING WARNING Refitting of the vehicle or removal of original parts may make the vehicle dangerous or illegal.
Camber adjustment method, Front wheel camber standards values is α﹣ 1°...
Page 11
Front toe adjustment method, Front wheel toe Standard value is 4MM( A+ 4MM=B)...
Page 12
The height of chassis is adjustable.( Warning: the screw of bearing joint must be tighten, tighten the screws can’t less than 15mm.)
Page 13
Push the front frame to reach the lowest position, adjust the limit screw beside right front shock absorber. Make sure the minimum distance between the tie rod linkage and frame is 10mm or greater.
VIN RECORD Please enter the VIN and engine code of your E-Spider in the blank below. These will assist with any future parts, service, or maintenance items needed, and can also aid in recovery of a stolen vehicle. 1. VIN 2.ENGINE CODE...
WARNING Lithium battery storage instructions 1. Lithium-ion batteries should be stored in a relatively cool, dry, and ventilated environment, and should be kept away from water, fire and high temperatures. The storage temperature of the battery must be within the range of -10℃~45℃, and the humidity should be 65±20%RH. 2.
Warning Before turning on the power switch, please depress the brake pedal to ensure safe operation of the braking system. braking state Do not drive until all instrument indicators are in normal condition...
CAUTION For new or inexperienced riders, change the speed and power levels to a low settings to prevent accidents. TIRES Proper air pressure will provide maximum stability, riding comfort and tire life. Check tire pressure frequently and adjust if necessary. Select the right replacement tires in accordance with the specifications shown in the table 1.
OPERATION GUIDE PRE-RIDE INSPECTION WARNING If the Pre-ride Inspection is not performed, severe injury to personnel or damage to equipment may occur. Inspect your ATV every day before you ride it. The item listed here will only take a few minutes to inspect, and in the long run they can save time, expense, and you life.
Page 21
STARTING THE VEHICLE Always follow the proper starting procedure described below. STARTING PROCEDURE BY THE STARTER BUTTON 1. Insert the ignition key into the ignition switch and turn to (ON). 2. Set the emergency switch to “ON”. BREAK-IN Help assure your vehicle’s future reliability and performance by paying extra attention to how you ride during the first two-week riding period.
Page 22
RIDING CAUTION Review Vehicle Safe Riding, before you ride. 1. After the main switch has been turned on, ensure all gauges and lighting are functional before riding 2. Open the throttle gradually so the vehicle moves forward. 3. To slow down the vehicle, reduce the throttle while applying pressure to the brake pedal. Coordinate the throttle with brakes for smooth deceleration.
PARKING 1. Close the throttle while applying the brakes to slow down the vehicle until it stops. 2. Turn the ignition key to (OFF), and remove the key. 3. Pull up to activate the Parking Brake lever between the seats of the vehicle. FRONT AND REAR HYDRAULIC DISC BRAKE The ATV is equipped with a set of 2 IN 1 single cylinder disc brake.
Page 24
CHECK OF BRAKE SYSTEM The brake system should be checked every day before you ride the vehicle. 1. Check the brake master cylinder for proper brake fluid level. 2. Check to see there is no leakage from the system 3. Check the brake hose and master cylinder for cracks 4.
Page 25
WARNING Brake fluid is a strong irritant, avoid contact with skin or eyes. In case of contact, flush thoroughly with water and consult a doctor if your eyes were exposed. ● Keep out of reach of children ● Replacement Brake fluid must be DOT3 or DOT4 standard. Never mix with other types of fluid, serious damage to brake system may occur.
For troubleshooting assistance, please contact your dealer. CAUTION Do not dismantle the vehicle. The E-Spider is powered by a high voltage system that can cause injury. CLEANING Clean your vehicle regularly to protect the surface finish and inspect for damage, wear, and oil or break fluid leakage.
Page 27
WARNING Braking efficiency may be temporarily impaired just after washing the vehicle. Leave a longer stopping distance to avoid a possible accident. 1. Test the brakes before riding the vehicle. Several applications may be necessary to restore normal braking performance. 2.
Page 28
MAINTENANCE MAINTENANCE SCHEDULE The following Maintenance Schedule specifies all maintenance required under normal conditions to keep your vehicle in optimal condition. Riding under unusually dusty or wet conditions, service of the vehicle should be made more often than specified in the schedule. Maintenance work should be performed by a properly trained technician. I: INSPECTAND CLEAN, ADJUST, LUBRICATE OR REPLACE IF NECESSARY C: CLEAN 1: LUBRICATE First week Every 30-day,s ride...
Page 29
Lithium battery storage and use instructions I. Description of lithium battery storage 1. Lithium-ion batteries should be stored in a cool, dry and ventilated environment, away from water sources, fire sources and high temperatures. The battery storage temperature must range from -10 ° C to 45 ° C, and the humidity must be 65± 20% RH. 2.
Page 30
1. Do not charge the battery near fire or in extremely hot conditions! Do not use or store batteries near heat sources such as fire or heaters. 2. Do not submerge the battery in water 3. Do not expose the battery to fire or heat the battery! 4.
Need help?
Do you have a question about the E-SPIDER and is the answer not in the manual?
Questions and answers