Husqvarna R115C Operator's Manual page 16

4. Press the clutch pedal down and select a gear.
Select gear 1–4 when you cut grass with the product.
Select gear 4–5 for transport of the product.
CAUTION: If a gear does not engage
immediately, do not use force. Release
the clutch pedal, press it down again and
try to engage the gear again.
Note: You can start the product on all 5 gears.
5. Slowly release the clutch pedal.
6. Lower the cutting deck.
7. To brake, press the parking brake/speed brake
pedal.
To start on a slope, R112C5
1. Select cutting height (1–5) with the cutting height
lever.
2. Start the engine.
3. Press the parking brake pedal down.
4. Apply full throttle.
5. Press the clutch pedal down and select first gear.
6. Slowly release the parking brake pedal and the
clutch pedal.
16
To stop the engine
1. Pull the lift lever for the cutting deck rearward to lift
up the cutting deck. The blades stop to rotate.
2. Put the throttle control in position (A).
B
A
a) For R112C, R115C, let the engine idle for a
minimum of 30 seconds.
b) For R112C5, put the gearshift lever in the neutral
position (N).
3. Turn the ignition key to the STOP position.
4. When the product stops, apply the parking brake.
To apply and release the parking brake
R112C, R115C has the parking brake pedal and the lock
button for the parking brake on the left side. R112C5
has the parking brake pedal and the lock button for the
parking brake on the right side.
1. Press the parking brake pedal down (A).
C
N
831 - 001 - 15.06.2018