Mounting The Guide Bar And Saw Chain - Makita DCS 34 Owner's And Safety Manual

STOP
A
B
C
5
D 7
18
4
6
PUTTING INTO OPERATION
CAUTION:
Before doing any work on the guide bar or chain, always
switch off the engine and pull the plug cap off the spark
plug (see "Replacing the spark plug"). Always wear protective
gloves!
CAUTION:
Start the chain saw only after having assembled it
completely and inspected!

Mounting the guide bar and saw chain

Use the universal wrench delivered with the chain saw for
the following work.
1 Put the chain saw on a stable surface and carry out the
following steps for mounting the guide bar and chain:
Release the chain brake by pulling the hand guard (1) in
2
direction of arrow.
Unscrew retaining nuts (2).
Pull off the sprocket guard (3).
3
Turn the chain adjusting screw (4) to the left (counterclock-
wise) until the pin (5) is at the left stop.
Position the guide bar (6). Make sure that the pin (7) of the
chain tightener is in the hole on the guide bar.