Technical Data; Specifications; Approved Bar And Chain Combinations - Makita DCS 34 Owner's And Safety Manual

Technical data

Single-cylinder two-stroke
Piston displacement
Cylinder bore
Piston stroke
Max. power at speed
Max. torque at speed
Idling speed
Sound Pressure Level at the operator's ear
at full load according to ANSI B 175.1
Sound Pressure Level at the bystander's position
(50ft/15 m distance) according to ANSI B 175.1
Ignition system
Electronic, without breaker
Spark plug
or Spark plug
Electrode gap
Fuel system
Carburetor (for Canada)
Carburetor (for USA)
(all position diaphragm carburetor
with integral fuel pump)
Fuel tank capacity
Fuel mixture
Weight
without cutting attachment
Cutting attachment
Guide bar
Cutting length
Safety saw chain (pitch) 3/8"
Drive link gauge
Chain sprocket
Chain lubrication
Oil tank capacity

Approved bar and chain combinations

"Low-kickback saw chain is a chain which has met the
kickback performance requirements of ANSI B 175.1-
1991 (American National Standard for Power Tools-
Gasoline-Powered Chain Saws-Safety Requirements)
when tested on the representative sample of chain
saws below 3.8. C.l.D. specifed in ANSI B 175.1-
1991". The approved bar and chain combinations are
low kickback chains according to ANSI B 175.1-1991
and also meet the kickback requirements of CSA
Z62.3-96 for chain saws below 80 cm
The chain saw DCS 34 has been approved with
following guide bar and chain combinations:
Drive link gauge .050"
Guide bar 3/8"
length Part no.
14" (35 cm) 442 035 661
16" (40 cm) 442 040 661
"There may be other replacement bar and chain combi-
nations available that also reduces the risk of injury
from kickback".
3 .
Saw chain 3/8"
Part no.
528 092 652
528 092 656
DCS 34
2.0 cu. in (33 cm
1.45" (37 mm)
1.22" (31 mm)
1.3/9,000 kW/rpm
1.7/6,500 Nm/rpm
2,800 rpm
98 db(A)
73 db(A)
NGK BPMR 7A
.020" (0.5 mm)
ZAMA
ZAMA with limiter caps
13.0 oz. (0.37 l)
see chapter "Fuel"
10 lbs. 5 oz. (4.7 kg)
sprocket nose bar
14" (35 cm) • 16" (40 cm)
(528 092 ...)
.050"
6 teeth
fully automatic oil pump
8.8 oz. (0.25 l)
WARNING
Do not use other replacement bars and chains
unless they have been designated as meeting the
ANSI B 175.1-1991 (for USA) and CSA Z62.3-96
(for Canada) kickback performance requirements
on that specific powerhead, or has been desig-
nated as "low kickback" saw chain in accordance
with the ANSI B 175.1-1991 (for USA) and CSA
Z62.3-96 (for Canada) standard.
3
)
17