Uvg-Slc96; Rx Lvl (Tlp) (Receive Level/Transmit Level Point) - ADTRAN FXS+ User Manual

the signalling for the T-Span
is set for UVG (Loop Start) at
the Digital Switch...
the signalling for the T-Span
is set for UVG (Ground
Start) at the Digital Switch...

RX LVL (TLP) (Receive Level/Transmit Level Point)

61202300L1-1
ration when the TSU/FXS+ combination acts as the
Remote Terminal.
Channel Test signalling is ignored and the Forward Dis-
connect feature is implemented by removing tip-ground
during the call. Line Side Answer Supervision is also
supported.

UVG-SLC96

This mode of operation will configure the port to use
Universal Voice Grade signalling on the T-span (as
defined by TR-TSY-000008) and either Loop Start or
Ground Start Supervision on the analog 2-wire interface.
LSAS is supported. The supervision on the 2-wire inter-
face is determined by the provisioning on the far side.
If...
No other settings are necessary to configure the supervi-
sion, as the far-end determines it. Channel Test signalling
is ignored.
RX LVL (TLP) sets the RX direction transmission level
points (TLP). The TLP is indicated in dB and the relative
loudness is indicated by a bar graph display. Settings
change immediately as the bar graph is scrolled.
Choice range: -8 dB to 0 dB, in 1 dB steps
FXS+ Quad Voice Option Module User Manual
Chapter 3. Operation
Then...
the FXS+ will have Loop Start
supervision on the 2-wire inter-
face.
the FXS+ will have Ground Start
supervision on the 2-wire inter-
face.
3-9