Advertisement
Before you use your table blender
Using your table blender
8
1.
Unpack the table blender and place all the parts on a horizontal surface.
2. Immerse the jar, the jar lid and the measuring cup in warm soapy
water, then rinse and dry them. Never immerse the motor unit in
water; you risk an electric shock.
!
CAUTION! The blade is very sharp. Please handle it carefully.
For vegetable and fruit juice
1
Place the blender on a flat surface. Make sure it is unplugged and
the speed knob is in the "off" position.
2
Prepare the vegetable or fruit, and place it into the jar. You may
need to add extra water to enable the blender to work properly
and achieve a good consistency. You should never exceed the
maximum level indicated on the jar.
3
Close the jar lid and place the measuring cup into position. If the
jar lid is not closed properly, the blender will not work.
4
Place the jar onto the jar base, and make sure it is installed correctly.
5
Plug in the blender.
6
Turn the speed knob to a speed setting between minimum and
maximum; the light ring will illuminate and the blender will start to
work. Alternatively, you can turn the speed knob to P (pulse) to
blend at high speed.
7
If you wish to add more ingredients to the jar while the blender is
working, you can remove the measuring cup and add them through
the jar lid before replacing the cup.
8
Once the mixture has achieved the desired consistency, turn the
speed knob to the "off" position.
9
Unplug the blender and then remove the jar from the motor unit.
Remove the jar cover, then pour and serve.
!
CAUTION!
-
Never use hot liquids or run an empty blender.
-
Do not attempt to remove the jar while the blender is working.
If you need to remove the jar, turn off the blender first.
-
Do not operate the blender for more than 3 minutes at a time,
and allow 5 minute rest time between 2 continuous cycles. If to
operate the blender up to 10 cycles continuously, must rest it for 30
minutes to cool it down to room temperature.
-
You must unplug the blender before removing the jar.
!
NOTE
-
The Smoothie, Auto clean and Ice crush buttons will not work when
the blender is running under a selected speed setting or the "P" setting.
-
When blending solid foods like vegetables or nuts with liquids,
a ratio of 2:3 is recommended. (2 parts solids, 3 parts liquids)
Advertisement
