Advertisement
10
To crush ice
1
Place the blender on a flat surface. Make sure it is unplugged and
the speed knob is in the "off" position.
2
Place up to eight cubes of 15mm height, length and depth into the
jar, and replace the jar lid and measuring cup. You may need to add
extra water; normally, a good ratio is 2 parts ice to 3 parts water.
Make sure the amount of ingredients does not exceed the maximum
level as indicated on the jar.
3
Close the jar lid and place the measuring cup in position. If the jar
lid is not closed properly, the blender will not work.
4
Place the jar onto the jar base, and make sure it is installed correctly.
5
Plug in the blender.
6
Turn the speed knob to "on". All three buttons on the motor unit
will blink.
7
Press the ice crush button. The indicator light will stop blinking
and remain lit, and the blender will start to work.
8
After crushing the ice, the blender will stop working automatically
and the indicators of three buttons will blink again.
9
Unplug the blender and then remove the jar from the motor unit.
Carefully remove the jar cover, and serve.
!
CAUTION!
-
Do not attempt to remove the jar while the blender is working.
If you need to remove the jar, turn off the blender first.
-
Do not use the product continuously for more than 3 minutes.
If using continuously for up to 3 minutes, allow a 2 minute rest
period afterwards.
-
Allow a 30 minute rest period if using the product for more than
30 minutes at a time.
-
You must unplug the blender before removing the jar.
!
Note
-
You cannot adjust the blender with the speed knob when the
appliance is running under the ice crush mode.
-
During the process of crushing ice, if you want to make the
appliance to stop working, you can press the ice crush button
again or turn the speed knob to the "off" position.
Advertisement
