Operation; Maintenance; Optional Accessories - Makita SA5040C Instruction Manual

OPERATION

WARNING:
It should never be necessary to
force the tool. The weight of the tool applies ade-
quate pressure. Forcing and excessive pressure
could cause dangerous disc breakage.
WARNING:
ALWAYS replace the disc if tool is
dropped during operation.
WARNING:
NEVER hit the workpiece with the
disc.
WARNING:
Avoid bouncing and snagging
the disc, especially when working corners,
sharp edges etc. This can cause loss of control and
kickback.
CAUTION:
Never switch on the tool when it
is in contact with the workpiece, it may cause an
injury to operator.
CAUTION:
Never run the tool without the
abrasive disc. You may seriously damage the pad.
CAUTION:
Always wear safety goggles or a
face shield during operation.
CAUTION:
After operation, always switch
off the tool and wait until the disc has come to a
complete stop before putting the tool down.
CAUTION:
ALWAYS hold the tool firmly with
one hand on housing and the other on the side
grip (handle).
Sanding operation
► Fig.12
ALWAYS hold the tool firmly with one hand on rear
handle and the other on the side handle.
Turn the tool on, and then apply the abrasive disc to the
workpiece.
In general, keep the abrasive disc at an angle of about
15 degrees to the workpiece surface.
Apply slight pressure only. Excessive pressure will
result in poor performance and premature wear to the
abrasive disc.
Operation with wire cup brush
Optional accessory
CAUTION:
Check operation of brush by run-
ning tool with no load, insuring that no one is in
front of or in line with brush.
NOTICE:
Avoid applying too much pressure
which causes over bending of wires when using
the wire cup brush. It may lead to premature
breakage.
Usage example: operation with wire cup brush
► Fig.13

MAINTENANCE

CAUTION:
Always be sure that the tool is
switched off and unplugged before attempting to
perform inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always
using Makita replacement parts.
Air vent cleaning
The tool and its air vents have to be kept clean.
Regularly clean the tool's air vents or whenever the
vents start to become obstructed.
► Fig.14: 1. Exhaust vent 2. Inhalation vent
When the head cover is installed on the tool, loosen the
screws, and pull out the head cover.
► Fig.15: 1. Screw
OPTIONAL
ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Side grip
• Pad
• Rubber pad
• Abrasive disc
• Wire cup brush
• Sanding lock nut
• Lock nut wrench
• Dust cover attachment
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
9 ENGLISH