Table of Contents
Advertisement
18
DIVERTER REPLACEMENT
4. Using a 28mm spanner or socket, undo the threaded collar & slide out. The diverter cartridge should
now slide out of the mixer's bore complete with O-ring.
5. If necessary, replace the cartridge with a new one. Alternatively, if the cartridge is functioning correctly,
clean it thoroughly & reuse it.
6. To refit, rotate the diverter cartridge spindle fully clockwise until it stops (overhead shower outlet fully
open position). Looking at the cartridge from the underside, the left port should be closed as
illustrated. Maintain this orientation of the diverter & slide it into the mixer body. Note: the two locator
pins on the front face of the diverter cartridge are different sizes to prevent incorrect installation.
Rotate spindle fully clockwise,
left port shown closed.
Line
marker
Arrow
marker
IMPORTANT: Before engaging the handle onto the diverter drive spindle, refit the plastic drive insert
then: Align the dot marker on the handle with the line marker on the stop-sleeve. Reverse the sequence
to refit the handle
1. Observe disassembling sequence, as detailed in
section 14, steps 1 to 3.
2. Remove the flow diverter handle (right side) as detailed in
section 16 steps 1 to 4.
3. Slide off the stop sleeve.
min. 4 Nm
max. 5 Nm
7. With the cartridge located back in the mixer bore, screw the
threaded collar into the mixer body by hand first & then tighten
with a spanner or socket. Ideally torque to 4Nm min to 5Nm max.
8. Refit the stop-sleeve. The front face is shaped to prevent
incorrect installation. When correctly positioned, the arrow on
the stop-sleeve will point between the two shower symbols on
the mixer body.
2 markers on
stop-sleeve
Threaded
collar
Ensure these locator pins are correctly located into
the plastic moulding inside the mixer body. The
diverter will then drop down to the correct depth.
Shower symbols
26
A7593AA & A7594AA
28
Stop
sleeve
Line
Dot
marker
marker
Arrow marker
Arrow
marker
Advertisement
Table of Contents
