3
1. Depth guide
2. Bolt (A)
3. Hex wrench
•
If you try to charge a battery cartridge from a just
operated tool, sometimes the charging light will not
come on. If this occurs, let the cartridge cool off for a
while. Then re-insert it and try to charge it once more.
•
When you charge a new battery cartridge or a battery
cartridge which has not been used for a long period of
time, it may not accept a full charge. This is a normal
condition and does not indicate a problem. You can
recharge the battery cartridge fully after discharging it
completely and recharging a couple of times.
•
When you charge a new battery cartridge or a battery
cartridge which has not been used for a long period,
sometimes the charging light will go out soon. If this
occurs, remove the battery cartridge and re-insert it. If
the charging light goes out within one minute even after
repeating this procedure a couple of times, the battery
cartridge is dead. Replace it with a new one.
•
If you wish to charge two battery cartridges, allow 15
minutes between charging on the charger.
Tips for maintaining maximum battery life
1. Charge the battery cartridge before completely dis-
charged.
Always stop tool operation and charge the battery car-
tridge when you notice less tool power.
2. Never recharge a fully charged battery cartridge.
Overcharging shortens the battery service life.
3. Charge the battery cartridge with room temperature at
10° C - 40° C (50° F - 104° F).
Let a hot battery cartridge cool down before charging it.
Adjusting the depth of cut
003509
Loosen the bolt (A) on the depth guide with the hex wrench
1
and move the base up or down. At the desired depth of cut,
2
secure the base by tightening the bolt (A).
9