Ultra Electronics Card Systems
Custom Key Data Form
For Rio 2, Tango 2, Rio 2e, Tango 2e & Tango +L
This form is used to specify the Custom Key for your Rio 2,
Tango 2, Rio 2e, Tango 2e or Tango +L ID card printer.
The Custom Key is the memory card device that :
•
Holds your HoloKote watermark custom design.
•
Can also be used as a Locking Key for your printer.
CONTACT INFORMATION
DEALER
Dealer _________________________
Contact ________________________
Phone _________________________
Email __________________________
P.O. # _________________________
ORDER INFORMATION
Order quantity _________________
Custom Key function (tick one or both) :
HoloKote custom design
Locking key
How will the logo be used?
Printed over entire card surface
Used only in one position
(mark one position on grid below)
Mark only one position on this grid.
Note : You do not need to specify the orientation (landscape or portrait) of the HoloKote logo as
the Rio 2 / Tango 2 driver allows you to choose either orientation in the driver user interface.
Page 1 of 3
CUSTOMER
Customer _______________________
Contact ________________________
Phone _________________________
Email __________________________
Signature ________________________
New Key
□
Repeat Key
□
Original key serial # ________________
How is the logo data being supplied?
□
Email (preferred method)
□
CD
www.magicard.com
□
□
□
□
August 2006