Table of Contents
Advertisement
4.
Connect an analog TV monitor to the Analog Video Output port. This optional step assists with
positioning and configuring the camera to produce the desired video scene.
Note: Do not remove the bottom cover from the camera. Removing this cover may allow
moisture to enter the camera and would void any warranty.
5.
Apply the mounting template to the mounting medium. Pre-drill the four perimeter holes for the
expansion bolts, using a drill bit that is no wider than the expansion bolt.
6.
Drill the center hole to route the cable from the camera through the installation medium.
7.
Insert an expansion bolt into each pre-drilled perimeter hole.
8.
Route the cables from the back of the camera through the installation medium and align the four
holes on the base of the camera with the expansion bolts.
9.
Insert a flat washer, then an elastic washer, and finally a nut onto each expansion bolt.
10. Secure a nut (with a wrench or a set of pliers) and use the Multi-purpose Tool to tighten the nut
onto the expansion bolt. Repeat this procedure with the other three (3) expansion bolts.
11. Adjust the sunshield, if necessary. Loosen the screw on the top of the camera and slide the
sunshield back and forth to the desired location, then tighten the screw.
12. Connect the external cables from the camera to the appropriate cables for Ethernet, power,
alarm I/O, and audio.
13. Attach the waterproof network connector if the camera is used outdoors.
a. Place the wide side of the rubber ring onto the end of the network cable extending out from
the camera.
b. Pull the waterproof cable end without the Ethernet connector through the body of the
Waterproof Connector. Thread the cable through the Fixing Rubber Ring and the Waterproof
Locking Cover.
c. Attach the male Ethernet connector to the network cable coming from the camera. Ensure the
Waterproof Connector shroud covers the Ethernet connection.
d. Connect the other end of the waterproof connector to the network port and rotate it clockwise
to lock the network port and waterproof connector firmly.
e. Slide the Waterproof Locking Cover over the main body of waterproof connector and rotate it
clockwise to seal the connection.
14. Press the Reset button for five (5) seconds to reset camera and to send video along the analog
connection, if connected.
Figure 4-3
11
Advertisement
Table of Contents
