Sp2400 Specifications - Mackie Sound Palette Series SP2400 Instruction Manual

SP2400 Specifications

Power Amplifier Section
Continuous Sine Wave Average Output Power, both channels
driven:
200 watts per channel into 8 ohms from 20Hz to 20kHz, with no
more than 0.01% THD
100V rms per channel into 50 ohms from 20Hz to 20kHz, with no
more than 0.1% THD (J2/J3 in 100V position)
70V rms per channel into 25 ohms from 20Hz to 20kHz, with no
more than 0.1% THD (J2/J3 in 70V position)
Frequency Response
20Hz to 20kHz (+0, –0.5 dB)
Distortion
THD: < 0.01% @ rated output into 8 ohms
Signal-To-Noise Ratio
> 90 dB below rated power into 8 ohms
> 100 dB (A-weighted) below rated power into 8 ohms
Channel Separation
> 80 dB @ 1kHz
Amp Input Impedance
20K ohms
Input Sensitivity
+5 dBu (1.37V rms) for rated power into 8 ohms
Gain
27 dB (8-ohm position)
27 dB (70V position)
30 dB (100V position)
Maximum Input Level
12 volts P-P (+15 dBu)
Rise Time
< 5 µS
Slew Rate
> 17 V/µS
Preamplifier Section
Input Levels
Program Inputs: –10 dBu to +10 dBu for
maximum output level
with internal AGC
Paging Mic Input: –52 dBu to +4 dBu
Local Mic Input: –52 dBu to +4 dBu
Maximum Input
Program Inputs: +15 dBu
Mic Inputs: +15 dBu
Maximum Output at Pre Out
+10 dBu
Stereo Separation
> 45 dB at 1kHz
SP2400 – 24
EQ
3-Band Program EQ:
±15 dB @ 12kHz
High Shelving:
±15 dB with sweepable frequency
Mid Peaking:
(250Hz to 8kHz)
±15 dB @ 80Hz
Low Shelving:
2-Band Mic EQ:
±12 dB @ 12kHz
High Shelving:
±12 dB @ 100Hz
Low Shelving:
General
Power Consumption
700 watts with musical program, 8 ohms per side
800 watts maximum
Phantom Power
24 VDC
AC Line Voltage
115VAC, 60Hz
230VAC, 50Hz
Fuse Rating
115V 8A Slow Blow, 250V
230V 4A Slow Blow, 250V
Dimensions
Height: 3.5" (88mm)
Width: 19" (483mm)
Depth: 16.7" (424mm)
Weight: 40 lbs. (18.1kg)
Accessories
MT-3100 Ambient Noise Sensing Microphone
SP-41R Remote Control