Installing the JFI-A1 filter
To install the JFI-A1 EMC filter,
1. Remove the UDC+/- and U1/V1/W1 terminal blocks (1), and the upper power
cable clamp plate (2) from the drive.
2. Fasten the mounting bracket (3) to the drive module base with two screws (4).
Tighten to 1.5 N·m (13 lbf·in).
3. Push the filter into place through the mounting bracket.
4. Fasten the filter to the mounting bracket with two screws (5). Tighten to 1.5 N·m
(13 lbf·in).
5. Fasten the top edge of the filter to the mounting base with two screws (6).
6. Fasten the power cable clamp plate at the top of the filter. Tighten to
1.5 N·m (13 lbf·in).
EMC filters 163