Date/Time Settings; Power Lamp - JVC GR-DVL40 Instructions Manual

8
EN

Power lamp

Power Switch
Display
FOCUS AUTO
EXPOSURE AUTO
W. BALANCE AUTO
FADER OFF
/ WIPE
P. AE OFF
/ EFFECT
4 TO MODE MENU 0
END
REC MODE SP
WIDE MODE OFF
ZOOM 64X
DIS ON
GAIN UP AGC
4 TO DATE / TIME MENU
TO SYSTEM MENU
– – – – – – – – – –
END 6
DATE/TIME
INDICATION ON
ON SCREEN OFF
DISPLAY ON
4 DATE / TIME 25 . 12 . 99
16 : 40
RETURN
MENU/BRIGHT
Dial
A
Recording Menu
Mode Menu
Date/Time Menu
GETTING STARTED

Date/Time Settings

The date/time is recorded onto the tape at all times, but its
display can be turned on or off during playback
( pg. 31).
1
Set the Power Switch to "
and the camcorder is turned on.
2
Press MENU/BRIGHT. The Recording Menu appears.
3
Move the highlight bar to "TO MODE MENU" by
rotating MENU/BRIGHT. Press it and the Mode Menu
appears.
4
Move the highlight bar to "TO DATE/TIME MENU"
by rotating MENU/BRIGHT. Press it and the Date/
Time Menu appears.
5
Move the highlight bar to "DATE/TIME" by rotating
MENU/BRIGHT. Press it and "day" is highlighted and
begins blinking.
Rotating MENU/BRIGHT, input the day. Press it.
Repeat to input the month, year, hour and minute.
Press MENU/BRIGHT twice when the highlight bar is
set to "RETURN" to exit.
Built-in Clock's Rechargeable Lithium Battery
To store the date/time in memory, the clock's rechargeable
lithium battery is integrated in the camcorder. While the
camcorder is connected to an AC outlet using the AC
Power Adapter/Charger, or while the battery pack attached
to the camcorder continues to supply power, the clock's
rechargeable lithium battery is always charged. However,
if the camcorder is not used for approx. 3 months, the
clock's lithium battery will become discharged and the
date/time stored in memory will be lost. When this occurs,
first connect the camcorder to an AC outlet using the AC
Power Adapter/Charger for over 24 hours to charge the
clock's rechargeable lithium battery. Then perform the
date/time setting before using the camcorder.
Note that the camcorder can be used without setting the
date/time.
NOTE:
Even if you select "DATE/TIME", if the parameter is not
highlighted the camcorder's internal clock continues to
operate. Once you move the highlight bar to the first date/
time parameter (day), the clock stops. When you finish
setting the minute and press MENU/BRIGHT, the date and
time begin operation from the date and time you just set.
(cont.)
". The power lamp lights