Output Mode; Stereo Mode; Bridge Mode - Sanway Audio HT-14K Manual

SANWAY AUDIO
Output Mode

Stereo Mode

Before setting the mode, please turn off the amplifier and slide the
mode select switch to below (Picture 1) . In this mode, Channel 1
an Channel 2 operate independently (Just traditional stereo
amplifier). The signal input into channel 1 can be output from
channel 1 only, similarly, the signal input into channel 2 can be
output from channel 2 only. The many channels, one by one in
order type pushes.
- +
Fans Speed

Bridge Mode

Before setting the mode, please turn off the amplifier and slide the
mode select switch to above (Picture 2), channel 1 and channel 2
are bridged.At time, the signal input into channel 1 will be output
from the bridge end. On other hand, the output level control of
channel 2 should be turn down to smallest. Only the volume
control of channel 1 are used to control the volume of whole
system.
- +
Fans Speed
http://www.china-sanway.com http://www.china-sanway.com
7
(Picture1)
( Picture2)