SANWAY AUDIO http://www.china-sanway.com http://www.china-sanway.com Important Note WARNING NOTICES SAFEGUARDS Electrical energy can perform many useful funtions, This unit has been engineered and manufactured to assure your personal safety. Imporoper use can result in potential electrical shock or fire hazards. In order not to defeat the safeguards, observe the following precautions for its installation, use and servicing.
SANWAY AUDIO http://www.china-sanway.com http://www.china-sanway.com Control elements Front Panel The front panel LED area includes the following indicators per channel: 1. LEVEL CONTROL Calibrated detente potentiometers to alter the total gain of the power amplifier. In order to avoid distortions in mixing consoles upstream, these controls should normally be positioned between 0 and 10.
Page 4
SANWAY AUDIO http://www.china-sanway.com http://www.china-sanway.com Rear panel features introduction DIP switches XLR connectors for 2 channel version Mains input 200V- 240V for adjusting key inputs and loop thru shown with Neutrik or 1 00V- 120V operation features Speakon output Fans Speed ( See below) connectors Rear view of 2-channel model fitted with Speakon Connectors...
Page 5
SANWAY AUDIO http://www.china-sanway.com http://www.china-sanway.com Rear panel features introduction VCL-Voltage Clip Limiter adjustment is provided for eight discrete levels for each channel. Select the setting most appropriate for connected speakers. Mode-Select VCL mode to either Hard or Soft operation. For channels driving sub-woofers and low-frequency drivers, it is recommended to use the Hard setting for optimal operation.
SANWAY AUDIO http://www.china-sanway.com http://www.china-sanway.com Audio input and output connections BALANCED INPUT CONNECTIONS The XLR input connectors are electronically balanced, and wired according to the IEC 268 standard ( pin 2= hot ). XLR input connectors should be wiredas follows: Pin 1 Ground/Shield Pin 2 Hot (+) Audio input-2-channel models Pin 3 Cold (-)
SANWAY AUDIO http://www.china-sanway.com http://www.china-sanway.com Output Mode Stereo Mode Before setting the mode, please turn off the amplifier and slide the mode select switch to below (Picture 1) . In this mode, Channel 1 an Channel 2 operate independently (Just traditional stereo amplifier).
Page 8
SANWAY AUDIO http://www.china-sanway.com http://www.china-sanway.com Professional Power Amplifier Specifications MODEL HT-14K Output Power 8R Stereo Power 2×2350W 4R Stereo Power 2×4400W 2R Stereo Power 2×7000W 8R Bridged Monon Power 8700W 4R Bridged Monon Power 13000W 20Hz-25kHz ±0.5dB FREQUENTY RESPONSE 0.10% THD+N(Rated power,4ohm/1KHz)% Signal Noise Ration(dB) 110dB 20Kohm Balanced / 10kohm Unbalanced...