Table of Contents
Advertisement
b.
Peel the tape off the connectors (1). Remove the two Phillips M 2.0 × 3.0 screws (2) from the
bracket, and then remove the bracket (3). Disconnect the cables that were under the bracket (4).
c.
Loosen the four Philips M2.0 × 2.0 screws (1) from the system board. Lift the board up slightly (2),
and then pull the cables out through the holes in the board (3).
d.
Peel the display cables off the computer.
Display cables are available in the Display Cable Kit as spare part number N22930-001.
Display panel and subcomponents
71
Advertisement
Table of Contents
