Advertisement
3
-B
Connecting an Android terminal to the printer
USB
interface
You will need:
• Prepare a USB cable and USB
adapter according to the connector
shape of the smartphone/tablet
that you use.
Printer-side plug
(Type B)
Connect the USB cable to the printer USB (Type B) connector
1
Connect the other plug to the smartphone/tablet
.
2
3
-C
Connecting a Mac/Linux terminal to the printer
Download the Mac CUPS driver or Linux CUPS driver.
For details, refer to the Online Manual.
Initializing the communication settings (For Wired LAN Interface)
If the communication connection is not suc-
Insert a pen with a small tip or similar item
and press the RESET button on the back
cessful, follow the procedure below and
At the same time, press the power switch on
initialize the communication setting.
the front of the printer until the POWER LED
After initialization, perform connection again
turns on (power ON)
starting from the beginning of 3-A, B, or D.
Keep pressing RESET switch until the Net-
work LED (green) on the front of the printer
<Procedure>
flashes
.
Check that the printer power is OFF.
Press and hold the FEED button
firm.
Wired LAN
interface
You will need:
• Commercially-available LAN cable
Connect the LAN cable to the printer LAN connector
.
LAN
1
Connect the other plug to the connector of the router, hub, or other
LAN device
.
2
DHCP is enabled by default for the wired LAN settings. To
continually use the same IP address, set a static IP address
before use.
For the static IP address setting procedure, refer to the On-
line Manual.
Download the Mac CUPS driver
●
www.star-m.jp/mac-cps.html
Download the Linux CUPS driver
●
www.star-m.jp/linux-cps.html
4
.
.
3
to con-
3
-D
Connecting a Windows tablet or PC terminal to the printer
Installing the Windows driver
Download [mCollection Printer Software].
Extract the downloaded software and execute "Setup.exe".
Follow the wizard instructions and complete software installation.
The Windows driver is included in the mCollection Printer Software.
The mCollection Printer Software can be used to configure the printer
settings and perform an operation test.
Printer-side plug
.
You will need:
• Prepare a USB cable and USB
adapter according to the connector
shape of the tablet or PC that you
use.
Be sure to install the Windows driver before connecting the USB
cable.
Connect the USB cable to the printer USB (Type B) connector
Connect the other plug to the connector of the Windows tablet/PC
Installing the rear cover
1
Installing the rear cover onto the back of the printer
Press the hooks A at the bottom of the rear cover into the notches in the
printer main unit
, then fit the hooks B on the left and right of the rear
cover into the printer main unit until they click into place
2
For the owners of other companies' trademarks mentioned in this document, see Trademarks in our website (https://www.star-m.jp/eng/trademarks.html).
USB
interface
You will need:
• Commercially-available LAN cable
Printer-side plug
(Type B)
Connect the LAN cable to the printer LAN connector
.
1
Connect the other plug to the connector of the router, hub, or other
LAN device
.
DHCP is enabled by default for the wired LAN settings. To
continually use the same IP address, set a static IP address
before use.
For the static IP address setting procedure, refer to the On-
2
line Manual.
.
Download the StarPRNT for
mCollection Windows driver
www.star-m.jp/mcprint-wsw.html
Wired LAN
interface
Printer side Plug
.
LAN
1
.
2
1
A
2
B
B
©
2018-2021 Star Micronics Co., Ltd.
Advertisement
