Charging Your Shark Ion Robot; Installing The Charging Dock; Important Charging Information; Battery Charge Indicator Lights - Shark ION RV750C Instructions Manual

CHARGING YOUR SHARK ION ROBOT™

IMPORTANT: Install
the charging dock in a
location that can be easily
accessed by your Shark
ION ROBOT.
Always keep the charging
dock plugged in, or the
Shark ION ROBOT will not
be able to automatically
return to the base.
The Shark ION ROBOT
will beep when it is first
connected to power or
when it starts charging on
the dock.
RECYCLING YOUR
BATTERY
When your robot's battery
needs to be replaced, dispose
of it or recycle it in accordance
with local ordinances or
regulations. In some areas,
it is illegal to place spent
lithium-ion batteries in the

INSTALLING THE CHARGING DOCK

trash or in a municipal solid
waste stream. Return spent Set the charging dock on a hard, level surface, with its back
batteries to an authorized
against the wall. Remove any objects that are closer than 3 feet
recycling center or to retailer
(1 meter) from either side of the base, or closer than 5 feet
for recycling. Contact your
(1.52 meters) from the front of the base. Plug the charging
local recycling center for
cable into the port on the side of the dock, and connect the
information on where to drop
charger plug to a wall outlet.
off the spent battery.

IMPORTANT CHARGING INFORMATION

The Shark ION ROBOT has a pre-installed rechargeable battery.
Battery must be fully charged before using. The power switch
must be in the ON position in order to charge the battery.
When the cleaning cycle is complete or the battery is running
low, Shark ION ROBOT will automatically return to the charging
dock.
If your unit doesn't return to the dock, the battery charge may
have run out. See charging instructions on page 10.
9
1-800-798-7398
1 m
1 m
1.52 m
✕
Shark ION ROBOT™ can be charged
three different ways:
1
Manually place Shark ION ROBOT on the
charging dock, aligning its charging pads
with the charging contacts on the base.
2 Using the app, press the DOCK button to
automatically send Shark ION ROBOT to
the charging dock.
3 To charge unit directly, plug the charger
into a wall outlet, then connect the charger
cable to the jack on the side of the Shark
ION ROBOT.
!
Clean
Dock Spot
Full Charge
Cycles While Charging

BATTERY CHARGE INDICATOR LIGHTS

While the battery is charging, all three blue
!
LED lights will cycle until fully charged.
Clean
Full Charge
Cycles While Charging
Dock Spot
As the unit cleans, its battery discharges.
The blue lights indicate how much charge is
remaining.
Full Charge Nearly Full Mid Charge Low Charge
If all the battery indicator lights are off, then
either the power switch is turned off or there
is no charge remaining. Turn the power switch
to the ON position. If all indicator lights remain
off, then charge the unit directly, using the
charger.
Full Charge Nearly Full Mid Charge Low Charge
s h a r kc l e a n . c o m
10