Maintenance - Husqvarna 135R Operator's Manual

To cut the grass
1. Make sure that the trimmer line is parallel to the
ground when you cut the grass.
2. Do not push the trimmer head to the ground. This
can cause damage to the product.
3. Move the product from side to side when you cut
grass. Use full speed.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
Maintenance schedule

Maintenance

Clean the external surface.
Examine the harness for damages.
Do a check for damages on the suspension ring.
Do a check of the throttle trigger lockout and the throttle trigger. Refer to
check of the throttle trigger lockout on page 7 .
Make sure that the cutting attachment does not rotate at idle speed.
Do a check of the stop switch. Refer to
7 .
975 - 005 - 14.11.2022
Maintenance
Read and understand the
To do a check of the stop switch on page
To sweep the grass
The airflow from the rotating trimmer line can be used to
remove cut grass from an area.
1. Hold the trimmer head and the trimmer line parallel
to the ground and above the ground.
2. Apply full throttle.
3. Move the trimmer head from side to side and sweep
the grass.
WARNING:
cover each time you assemble new trimmer
line to prevent unbalance and vibrations in
the handles. Also do a check of the other
parts of the trimmer head and clean it if
necessary.
CAUTION:
remove the spark plug cap from the spark
plug before you do maintenance on the
product.
To do a
Clean the trimmer head
To prevent accidental start,
Daily Weekly Monthly
X
X
X
X
X
X
19