LG WD-12471BDM Service Manual page 17

ERROR SYMPTOM
8
CURRENT
ERROR
MOTOR
9
ERROR
BALL
11
SENSOR
ERROR
EEPROM
12
ERROR
POWER
13
FAILURE
• MAIN PWB ASSEMBLY is out of order
Replace the MAIN PWB ASSEMBLY
• Winding in the STATOR ASSEMBLY is short-circuited.
Replace the STATOR ASSEMBLY
• " " is dispplayed during a high spin
Replace the LEAD WIRE ASSEMBLY (MOTOR)
• The connector in the LEAD WIRE ASSEMBLY is not connected to
the connnector of STATOR ASSEMBLY
Reconnect or repair the connector
• The hall sensor is out of order/defective.
Replace the STATOR ASSEMBLY
• Loose Ball Sensor Connector.
• Ball Sensor is out of order.
※ Displayed only when the START/PAUSE button is first
pressed in the QC Test Mode.
• EEPROM is out of order.
※ Displayed only when the START/PAUSE button is first
pressed in the QC Test Mode.
• The washer experienced a power failure.
• Restart the cycle.
16
CAUSE