Templates supported by E-kit
Available templates and models The list of templates could be extended in future. you can find the complete list of templates with also ready-
Structure of E-kit
Access to the web interface
SD card functions
7 | © 2022 ABB | - 1SDH002203A1002
The keypad used for communicating with the interface of E-kit includes the following commands:
1.
RUN
2.
VAL
3.
ESC
4.
OK: for saving new settings
5.
DIAG
6.
CFG: for accessing the menu to configure the IP address of E-kit
7.
: for moving among the menu options
8.
: for moving among the menu options
E-kit allows different families of devices to be integrated. A dedicated template is available for each family with
the main measurements managed by the devices of the family.
A list of the available templates is given below:
1.
Meter
2.
Breaker
3.
Digital Input – output
4.
Analog input – output
5.
Protection relay
6.
Battery rack – BMS
7.
PV string inverter
8.
ESS inverter
9.
Temperature Monitoring Device
10. Motor drive and softstarter
11. Gen Set Controller
to-use models available for ABB devices
E-kit consists of a CPU with a COM1 serial port, two Ethernet ports (used as a switch for Ethernet
connection). An SD card is also supplied with E-kit.
E-kit has an integrated web server presenting a web interface for the purpose of configuring and
displaying all the states of the devices connected.
The web interface can be accessed in the following ways:
•
via the browser, by entering the IP address set during the configuration process in the address bar (see
Setting of static IP address (recommended).
•
via
e
c
3
software (see Integration with Ekip Connect 3).
kip
onnect
The SD card provided in E-kit enables the following functions to be performed:
•
Update the software of E-kit
•
Backup the configuration created
•
Update the catalog of templates and models supported by E-kit
.
here
ABB | E-kit
Overview of E-kit