Table of Contents
Advertisement
CPU Installation Procedures for Socket 940
1. Make sure that the computer is
turned off, and the power cord
disconnected before installing
the CPU.
2. Pull the lever sideways away
from the socket, and raise it up
to a 90-degree angle.
3. Locate the cut edge of the CPU.
When the CPU is installed into the
socket, this cut edge should be
aligned with the corner marking
an arrow on the Socket 940.
Please note that the CPU can only
fit in a correct orientation. DO
NOT use force to install the CPU
into the socket.
4. Place the CPU onto the socket
and press it down firmly into the
socket. The pins of the CPU
should be embedded into the
socket completely.
5. Close the lever to secure the
CPU. Do not close the level until
the CPU's pins are fully inserted;
otherwise, the pins may be
damaged.
Open Lever
Corner marking
an arrow
Press down
the CPU
O
Hardware Setup
Cut edge
Close
Lever
X
2-3
Advertisement
Table of Contents
