Advertisement
D. INSTRUCTIONS
1. Install the blade cover (part D) onto the motor module (part C) and secure it with two screws (part R).
2. Push the T tube (part G) onto the motor module.
3. Place the assembled module in the water container (part A) as shown.
4. Add the container cover (part E) to the water container. Make sure the motor wires pass through the square hole in the cover. Secure
the cover with four screws (part R).
5. Pass the red and black wires through the small hole in the container cover so that they appear in the bottom of the container.
6. Insert the wires into the terminals as shown and insert the terminal caps (part P) to secure the wires in place.
7. Add the wire cover (part F) to the underside of the container and secure it with a screw (part R).
8. Install 2 AAA batteries into the battery compartment, then add the battery cover (part M) and secure it with a screw.
9. Install the disk (part I), transparent tube (part K) and water tray (part B) as shown. Turn the direction of the water tray so that the
dripping spouts are not pointing to the edges of the container, to avoid water spilling out.
10. Press the unicorn figurine holder (part L) onto the top of the transparent tube, then insert the unicorn figurine (part J) as shown.
11. Screw the castle base (part H) to the container cover, then insert the castle roofs (part O) onto the castle top.
12. Insert the 4 small flowers (part Q) into the 4 corners of the container cover. Decorate the fountain and castle with the sticker sheet
(part N) provided.
Advertisement
