Table of Contents
Advertisement
I/O Devices Configuration
Press <Enter> to enter the sub-menu and the following screen appears:
OnBoard Floppy Controller
This item allows you to enable/ disable the floppy controller. Setting options:
[Disabled], [Enabled].
COM Port 1/ 2
Select an address and corresponding interrupt for Serial Port 1/ 2. Setting options:
[3F8/IRQ4], [2E8/IRQ3], [3E8/IRQ4], [2F8/IRQ3], [Disabled].
Parallel Port
This specifies the I/O port address and IRQ of the onboard parallel port. Setting
options: [378/IRQ7], [278/IRQ5], [3BC/IRQ7], [Disabled].
Parallel Port M ode
[EPP]
[ECP]
[ECP + EPP]
[Normal]
[Bi-Directional]
To operate the onboard parallel port as Standard Parallel Port only, choose [SPP].
To operate the onboard parallel port in the EPP mode simultaneously, choose
[EPP]. By choosing [ECP], the onboard parallel port will operate in ECP mode only.
Choosing [ECP + EPP] will allow the onboard parallel port to support both the ECP
and EPP modes simultaneously.
Parallel Port IRQ
This item allows you to set parallel port IRQ. Setting options: [IRQ5], [IRQ7].
Enhanced Parallel Port
Extended Capability Port
Extended Capability Port + Enhanced Parallel Port
BIOS Setup
3-15
Hide quick links:
Advertisement
Table of Contents
