Table of Contents
Advertisement
2
Drive a wood screw through the mounting
bracket and into the cabinet frame.
3
Reinstall the plastic caps.
Attaching Toe Kick
1
Attach the provided lower cover to the base of
the dishwasher.
2
Attach a custom toe kick. If needed, use a saw
to cut a notch in the top of the custom toe kick
to provide clearance for the cabinet panel
when opening the door.
Final Installation Check
Testing the Dishwasher
Check if the dishwasher is properly installed.
1
Turn on the circuit breaker.
2
Turn on the house water supply.
3
Make sure that the door opens and closes
smoothly.
• If necessary, level the dishwasher again.
• If the door will not close, make sure the rack
is level.
• Make sure that all packaging materials have
been removed.
4
Power on the dishwasher and run a Turbo
cycle to verify proper operation.
5
Check for leaks at the drain hose and water
supply connection.
6
If a water leak is detected, press and hold the
Start button for 3 seconds to cancel the wash
cycle and automatically drain the water from
the dishwasher. Tighten all water connections
and run another cycle. Repeat until no leaks
are detected.
7
Remove the protective film from the door, if
present. Leaving the film on may cause
discoloration or condensation on the door.
INSTALLATION
19
Advertisement
Table of Contents
