Checking Cleanliness And Condensation; Checking The Screws; Replacing The Air Filter Inserts; Figure 42: Air Filter Inlet - Alpitronic Hypercharger HYC 50 Operating And Installation Manual

Page 70 of 76
8.4.

Checking cleanliness and condensation

Check that the interior of the column is clean and shows no signs of condensation.
8.5.

Checking the screws

Check the tightening torques on terminals and mechanical screw connections randomly or
completely.
Assembly
PCB
Busbars

Table 12: Torque of components

Information
8.6.

Replacing the air filter inserts

Replace the air filter inserts regularly.

Figure 42: Air filter inlet

All rights reserved. Reproduction of this document, in whole or in part, is only permitted with the permission of alpitronic GmbH.
Torque
1...2,5 Nm
5 Nm
If you have any uncertainties regarding tightening torques, please feel free
to contact our support team.
support@hypercharger.it
HYC_50 – Operation and Installation Guide
or +39 0471 1961 333
Hardware
Version 1-2
8 Maintenance