Kärcher IVM 40/24-2 H ACD Manual page 26

4. Fit the dust bag in the dirt receptacle and
carefully position it against the container
wall and the container floor.
5. Fold the edge of the dust bag over the
edge of the dirt receptacle to the outside.
Fitting the safety filter bag
Illustration F
6. Fit the safety filter bag.
Illustration G
7. Fold the edge of the safety filter bag out
over the edge of the dirt receptacle.
WARNING
Improper handling when locking the dirt
receptacle
Risk of crushing
Under no circumstances should you hold
your hands between the dirt receptacle and
filter ring or allow them to come close to the
lifting mechanism while locking it.
Lock the dirt receptacle by operating the
bow handle with both hands.
Illustration H
ATTENTION
Static charge of the dirt receptacle
Ignition of dusts
Make sure that the grounding on the chas-
sis is in contact with the dirt receptacle.
8. Fit the dirt receptacle and lock it with the
bow handle.
Wet vacuum cleaning
DANGER
Danger from dust that is harmful to your
health
Respiratory sicknesses through inhalation
of dust.
No dusts harmful to health may be vacu-
umed when performing wet vacuum clean-
ing.
ATTENTION
Risk of damage if the dirt receptacle
overflows
The dirt receptacle can fill within a few sec-
onds and overflow when vacuuming large
amounts of liquids.
Continuously monitor the filling level.
1. Remove the dust bag or the safety filter
bag before wet vacuum cleaning (see
26
chapter Removing the dust bag/ safety
filter bag).
Removing the dust bag/ safety filter bag
1. Secure the device with the parking
brakes.
2. Remove the suction hose if necessary.
3. Close the suction connection on the dirt
receptacle (see chapter Closing the
suction connection).
Illustration C
4. Pull the bow handle up.
The dirt receptacle is unlocked and low-
ered.
Illustration D
5. Pull the dirt receptacle out of the device
by the bow handle.
Removing the dust bag
Illustration I
6. Turn up the dust bag.
7. Seal the dust bag tightly with the cable
tie.
8. Remove the dust bag.
9. Dispose of the dust bag in accordance
with statutory regulations.
Removing the safety filter bag
Illustration J
10.Fold up the safety filter bag.
Illustration K
11.Peel off the protective film.
12.Close the safety filter bag with the self-
adhesive flap.
13.Pull the safety filter bag out towards the
rear.
Illustration L
14.Seal the suction connection opening of
the safety filter bag tightly with the cover.
Illustration M
15.Close the safety filter bag tightly with the
attached cable tie.
16.Remove the safety filter bag from the
dirt receptacle.
17.Clean the interior of the dirt receptacle
with a moist cloth.
18.Dispose of the used safety filter bag in
dust-tight bag in accordance with statu-
tory regulations.
English