Hover-1 BEAST BUGGY Operation Manual page 6

ASSEMBLING YOUR HOVER-1 BEAST BUGGY
1. Remove all of the Hover-1 Beast Buggy contents from the box. Ensure all the contents from the "PARTS LIST"
section are accounted for.
2. Insert the left and right handlebar mounts into the seat frame as shown below. Align the holes of the handlebar
mounts with the holes in the seat frame. Insert the M8 X 38 screws into the seat frame holes and attach the 8 mm
nuts to the end of the screws by twisting them on clockwise. Once the nuts are attached, hold the 8 mm nuts in
place with the wrench and turn the screws clockwise with the smaller hex key to tighten the screws. Make sure
both screws are tightly secured.
6