Safety Alerts - Hover-1 SYPHER Operation Manual

SAFETY ALERTS

If a system error occurs or an improper operation is performed while
riding the Sypher, the device will alert the user in a variety
of ways.
You will notice the running indicator light will turn red and you will hear a
beep sound, alerting you to take precaution and cease operation. The
hoverboard may stop suddenly.
The following are common occurrences that will produce safety alerts.
These notices should not be ignored, and appropriate action should be
taken to correct any improper operation, failure, or errors.
• Unsafe riding surfaces (uneven, too steep, unsafe, etc.)
• Battery voltage is too low.
• The Sypher is still charging.
• During operation, the platform self initiates to tilt due to excess speed.
• The hoverboard is overheating, or the motor temperature is too high.
• The Sypher has been rocking back and forth for over 30 seconds.
• If the system enters protection mode, the alarm indicator will light up
and the hoverboard will vibrate. This typically occurs when the battery is
about to run out of power.
• If the platform is tilted forward or backward more than 10 degrees,
the Sypher will power o and stop suddenly, possibly causing the
rider to lose balance or fall o .
• If any or both tires are blocked, the Sypher will stop after 2
seconds.
• When the battery level has depleted below protection mode, the Sypher
will power o and stop after 15 seconds.
• If a high discharge current is produced during use (such as driving up a
steep slope for a long period of time), the Sypher will power o and stop
after 15 seconds.
18