Advertisement
4. Align the holes of the seat with the highlighted holes of the seat frame as show below. Insert the 4 silver washers
into the seat holes, then insert the M6 X16 screws. Attach the 6 mm nuts to the bottom of each screw, under the
seat frame. Twist the nuts on clockwise. Hold the 6 mm nuts still with the wrench while turning the screws clockwise
with the larger hex key to tighten the screws. Make sure all 4 screws are tightly secured.
5. Your Hover-1 Kart is now assembled and should look like the image below.
7
Advertisement
