Ii - 1 Installation Setup; Installation Setup Parameters; Encoder Setup - ACU-RITE VUE Reference Manual

Hide thumbs Also See for VUE:

Table of Contents

II – 1 Installation Setup

Installation Setup is accessed by pressing the SETUP soft key, which

brings up INSTALL. SETUP soft key.

Installation Setup parameters are established during the initial

installation, and most likely, will not often change. For this reason, the

installation setup parameters are protected by the passcode.

See "Readout Parameter Access Code" on page v.

After entering the Access Code, the cursor will default to the Encoder

Setup field upon opening Installation Setup.

The Encoder Setup form is used to set the encoder resolution, and

type (linear, rotary), count direction, reference mark type.

Press ENTER. This opens a list of possible encoder inputs.

Scroll to the encoder to be changed, and press ENTER.

Cursor will be in the Encoder Type field. Select the encoder type by

pressing the LINEAR/ROTARY soft key.

For linear encoders, cursor to the Resolution field and use the

COARSER, or FINER soft keys to select the encoder's resolution (in

µm 10, 5, 2, 1, 0.5). The exact resolution can also be entered using

the numeric key pad. For rotary encoders, enter the number of

counts per revolution.

In the Reference Mark field, toggling the REF MARK soft key selects

whether the encoder has no reference signal with NONE, single

reference mark with the SINGLE or with the P-TRAC soft key for

encoders with the Position-Trac™ feature.

In the Count Direction field, select the count direction by pressing

the POSITIVE, or NEGATIVE soft key. If the encoder's count

direction matches the user's count direction, select positive. If the

directions do not match, select negative.

VUE

Table of Contents