Withings Body Scan User Manual page 4

! Warnings & safety notice
- Portable RF communications equipment (including peripherals
such as antenna cables and external antennas) should be
EN EN
used no closer than 30 cm (12 inches) to any part of the device,
FR
including cables specified by the manufacturer. Otherwise,
DE
degradation of the performance of this equipment could result.
SV
- Use of this equipment adjacent to or stacked with other equipment
NL
should be avoided because it could result in improper operation.
FI
If such use is necessary, this equipment and the other equipment
DA
should be observed to verify that they are operating normally.
IT
- Follow operational and storage conditions as described in
ES
the technical specifications section of the device's instructions
CS
for use. Otherwise, measurement results may be impacted.
PL
- To recharge the battery, use a power cord that complies with
PT the safety standards of the country in which it is used and that
matches the voltage of the power outlet.
RO
- The power cord of the charger and the handle cable may cause
HU
a strangulation effect due to excessive length. Keep it away
SK
from children and pets.
ET
- Do not open or disassemble the device for battery replacement.
EL
IS
LV
LT
SL
TR
BG
HR
How to use Withings Body Scan
and take a first measurement
- Follow the information in the Quick Start Guide and in the
Withings application to set-up your device.
- To wake up your device for the first time, please press the power
button for 3 seconds. If your product is not starting, consider
charging it for a minimum of three hours and try again.
- Once your product is installed and configured, it will appear
in your devices list in settings.
- To take the first measurement, grab the handle (optional)
and step on the scale with bare feet. Your name, or trigram
(as configured in the app), will appear on the scale's screen
at the end of the weight measurement: it means your scale
has correctly identified you and the measurements sequence
(as defined in the app) will follow.
- If it is not the case, the measurement will most likely appear
in "Unknown Measurements" in the application. Please assign
it to your user so that the scale can automatically recognize
the user during the next weigh-in.