Advertisement
1-5. Mounting body
Base unit
2
1
Fasten the base unit to the mounting bracket fixed on the wall.
2
Tighten the screw to prevent the base unit movement.
The default network type of InSight is dynamic.
If you have a DHCP server, it will automatically set the InSight.
Step
2
IP address settings
If you do not have a DHCP server, it will set as follows after one minute.
Initial address: Refer to the label on the InSight
User name: root
Default password: OPTEX
Change your password as appropriate.
Download IP installer;
IP installer is available as a dedicated software for searching
IP addresses of CUBE.
See our website. www.optexamerica.com
Step
4
Testing
4-1. Walk test and camera angle checking
Walk in the detection area to check the detecting performance via LED indication.
Mounting Bracket
1
Jump to Step 3
1
Step
3
Device registration to CHeKT portal
Setup your CHeKT Dealer Portal:
1. Go to http://dealer.chekt.com/ to log in.
2. Select the Customer on the left side of the dashboard.
3. Select the Site Devices tab.
4. Select the bridge device to be associated with the sensor camera.
5. Access the bridge settings using the gear icon to its right.
6. Select the appropriate tab to register the PIR camera.
Refer to the site for more details.
4-2. System test
Check the image at the time of detection
on the monitoring portal.
3
Press the buttons on both sides to install
1
the main unit.
Fasten the accessory screw to secure the main unit.
2
CHeKT suppor
https://support.chekt.com
Advertisement
