Using your beverage cooler
Display
When you plug in your beverage cooler for the first time, the display screen turns on for
three seconds, then the start-up tone rings.
CAUTIONS:
• The control buttons should be pressed gently.
• Avoid scratching the control panel with sharp objects.
• Keep magnets away from the control panel. Otherwise your cooler does
not set and operate normally.
Standby mode
To enter standby mode, press the Standby button continuously for three seconds. The
buzzer sounds and the display turns off.
To return to normal mode, press and hold the Standby button for three seconds.
Light button
Press the Light button to turn on or turn off the light. The buzzer sounds when the light is
turned on or off.
Setting the temperature
Press the Temperature Up (
decrease the temperature by one degree.
The temperature range is 34° ~ 50° F (1° ~ 10° C).
Switching the temperature setting between Fahrenheit and Celsius
Press and hold the Temperature Up (
same time for three seconds to switch between Fahrenheit and Celsius.
Quick Cool mode
After adding a large number of beverages, use Quick Cool mode to cool them down
quickly. The cooler remains in this mode for 24 hours or until you turn it off.
Press and hold the Standby and Light buttons for three seconds to turn Quick Cool
mode on or off. The display shows "FC" when in Quick Cool mode.
Memory function
When your cooler is turned off, it remembers the currently set temperature and returns to
that setting when it's turned back on.
8
Light
Standby
Display
button
button
) or Temperature Down (
) and Temperature Down (
www.insigniaproducts.com
Temperature up/down
buttons
) button to increase or
) buttons at the