Operating The Charger - Spektrum S100 Instruction Manual

Operating the Charger

Buttons
Operation of the charger is accomplished using the
push buttons on the top of the charger.
Battery
Type
• Press the Battery Type button to select the
correct battery type.
• Press the Output Current button to select the
appropriate charge output current.
• Press the Start/Stop button to begin or end the
charging cycle.
Charging
WARNING: Always check charging
parameters before initiating the charge
process. Charging any battery with improper
settings, including charging a battery in the wrong
mode, can result in property damage and fire.
Smart Batteries
If charging a Spektrum Smart Battery, the battery type,
charge current rate and capacity are set automatically
and the charger will begin charging automatically
when the battery and the balance lead (if available) are
connected to the charger. G1 Spektrum Smart batteries
are compatible with G2 Spektrum Smart chargers.
Output Start/Stop
Current Charging
Display
Battery
Type
Output
Current
Charge Port Connector Selection
The charging port is capable of charging with an
IC3 or IC5 connector.
• Slide the port cover down to
use the IC3 connector.
• Slide the port cover up to use
the IC5 connector.
IMPORTANT: Do not remove the charging port cover.
1. To power on the charger, connect a recommended
USB-C power supply (not included ) and the
included USB-C cable to the input port on the
S100 charger. The charger will beep twice to
indicate power is on, and the percentage indicator
bars will briefly display the input voltage.
Input Voltage
Indicator Bars Voltage Power Supply Wattage
20 glows 5V
20– 40 glow 9V
20– 60 glow 12V
20– 80 glow
15V
20–100 glow 20V
Charge Complete
Charging Error
Percentage
Indicator
10-20W
21-40W
41-60W
61-80W
81-100W