Advertisement
1. Highlight the
the first digit, then press → to move to the next number. Repeat those
steps until the correct amount of fuel added is input, then press
2. Press ↓ to
A
message. To confirm the selection of add fuel, press ←|
Fill Tank
When using the EP-10 Fuel Flow on your vessel, you must use either
the Add Fuel or Fill Tank commands when fuel is added to the tank.
The
command is used when you refill the fuel tank.
F
T
ILL
ANK
It always will be followed by an option to recalibrate the tank. Tank
recalibration is described below under the heading To Recalibrate.
1. After the tank has been filled, select
agement menu and press
confirm the selection of fill tank, press ←|
2. That will launch another message window which will give you the
option of recalibrating the tank. We just want to fill the tank without
recalibrating, so choose
Fill Tank highlighted on Fuel Management menu (left). Fill Tank con-
WARNING:
Carefully follow these instructions, otherwise fuel cali-
bration could be inaccurate, resulting in incorrect Fuel
Management.
To Recalibrate
To calibrate the EP-10 Fuel Flow, you must use the Fill Tank option.
1. After filling the tank, input the amount of fuel added to the tank in
the Fuel Added window. Use ↑ ↓ to enter the first digit, then press → to
move to the next number. When the correct amount of fuel added has
been input, press
dialog box and press
F
A
UEL
DDED
and press
F
DD
UEL
ENT
and press
N
O
firmation message (right).
.
ENT
, which will launch a confirmation
ENT
F
ILL
. A confirmation message will appear. To
ENT
.
ENT
9
. Use ↑ ↓ to enter
ENT
.
ENT
from the Fuel Man-
T
ANK
.
.
ENT
Advertisement
