Advertisement
To change Location:
1. From device configuration menu, press ↓ to
2. Use ↑ ↓ to select the desired location and press
message will appear. To confirm the configuration, press ←|
To change Fluid Type:
1. From the device configuration menu, select
2. Highlight the desired fluid type — Fuel, Water, Gray Water, Live
Well, Oil or Black Water — and press
appear. To confirm the configuration, press ←|
To change Tank Size:
1. From the device configuration menu, select
2. Use ↑ ↓ to change the first digit, then press → to the next digit. Re-
peat those steps until the correct tank size has been entered, then press
. A confirmation message will appear. To confirm the configuration,
ENT
press ←|
.
ENT
Calibration
Calibrating Fluid level is an important step to ensuring the status of
your tank is correctly transmitted over the NMEA 2000 buss.
For example: if you have an odd-shaped tank, like one that is wider at
the top than at the bottom, the float inside the tank will tell you there
is a half tank of gas when it reaches the midpoint of the tank, regard-
less of the tank's actual capacity below the midpoint. That could cause
you to run out of gas more quickly than expected. Whether the Fluid
Type is Fuel, Water, Gray Water, Live Well, Oil or Black Water, cali-
brating the Fluid Level protects you from unpleasant surprises.
To Calibrate a Device:
From the device configuration menu, press ↓
access the Device Calibration window.
2-Point Calibration
2-Point calibration is best for rectangular or square shaped tanks that
allow the fuel level sensor to provide an accurate reading of the fuel
level at the top and bottom of the tank. When you select 2-point from
the Num Pts menu, the Fluid menu will have two options: Empty Level
and Full Level.
1. Highlight
N
, press
P
ENT
UM
TS
. A confirmation message will
ENT
and select
. Press
2
4
and press
L
OCATION
. A confirmation
ENT
and press
F
T
LUID
YPE
.
ENT
and press
T
S
ANK
IZE
and press
C
ALIBRATE
.
ENT
.
ENT
.
ENT
.
ENT
.
ENT
to
ENT
Advertisement
