Lowrance M52 S/GPS Installation And Operation Instructions Manual page 92

Sequence for setting a waypoint. Step 1: while traveling, quickly press
WPT twice to call up Find Waypoint screen (shown at left) and set a
point. Step 2: a message says the waypoint has been saved (shown cen-
ter). Step 3: vehicle continues on its way; number waypoint symbol is
NOTE:
The Quick Save method uses the default waypoint symbol until you
edit an existing waypoint and change its symbol. After you have
changed a waypoint symbol, the unit will remember the one you
chose and use it the next time you "quick save" a waypoint. To re-
vert back to the default symbol, edit a waypoint and choose it, or
use the Reset Options command (described in Sec. 7).
Create Waypoint on Plotter
1. Use the arrow keys to move the cursor to the place where you want
to make a waypoint.
2. Press |
WPT
name with a sequential number, such as "waypoint 001." The waypoint
symbol and number appear on the plotter.
Create Waypoint by Entering a Position
1. Press |↓ to
WPT
2. Press ↓ to
E
3. Press ↓ to
change the first character, then press → to the next character and re-
peat until the latitude is correct. Press
4. Press ↓ to
change the first character, then press → to the next character and repeat
until the longitude is correct. Press
visible on plotter (shown at right).
. The waypoint is saved and automatically given a
WPT
C N
REATE EW
P
NTERED OSITION
|
L ENT
ATITUDE
|
L ENT
ONGITUDE
| .
ENT
| | .
ENT ENT
. Enter the latitude by pressing ↑ or ↓ to
ENT
. Enter the longitude by pressing ↑ or ↓ to
, then
ENT
86
.
| to return to the
EXIT EXIT