Permobil 1825813 Assembly Instruction

Document type
Assembly Instruction
Document No. Revision
gggg gg
246363 A.00
Production state
ggggggg
Preform Date
ggggggg
2010-12-22

Mounting the raising handle

Order no.: 1825813

List of parts in the set.

1 x left handle incl. bracket
1 x right handle incl. bracket

Mounting

Read the instructions carefully before starting
installation.
1. Remove the rear plastic plugs on the seat's left
or right UniTrack rail. (Fig. 1).
2. Undo the screws on the raising handle so that
it is possible to slide the track nuts into the
UniTrack rail's two grooves. (Fig. 2).
3. Slide the bracket's groove nuts into the rails
and place the brackets into the required position.
4. Tighten the screws.
5. Slide the handles down into the brackets and
tighten the locking lever. Check that the handle
is secure.
6. Replace the plastic plug on the UniTrack rails.
Fig. 2. Mount the bracket.
Preform By Approved Date
ggg ggggggg ggg
UDN
Raising handle
Approved By
Fig. 1. Remove the plastic plug
Fig. 3. The raising handle mounted on Corpus 3G.
Page
1