Zontes ZT350T-D Maintenance Manual page 139

c. open the brake pads on the rear brake caliper with a flat-
blade or other suitable tool, then install the brake caliper on
the rear rocker arm, and then install 2 M8×37 bolts⑹, use
14# set Tighten the barrel, torque: 24N.m (2.4 kgf.m, 18
lbf.ft); then connect the wheel speed sensor plug back to the
corresponding position, install a M6×12 bolt⑸, use 4# inner
hexagon to tighten ; Finally, install all the pipes connecting
the brake calipers and the wheel speed sensor into the
corresponding clamps, and arrange the lines.
d. One person uses 21 # socket to extend into the front of
the fine filter to fix one nut (2) on the left side of the
motorcycle to fix the engine, and the other person uses 24 #
socket to replace one bolt (1) on the right side of the
motorcycle to fix the engine
e. Install the muffler back according to "Removing the
muffler"
f. Refer to Adding Coolant to the Main Water Tank and add
proper amount of coolant
139 / 152