Configure The Netviewer For Network Viewing; Network Configuration - Lorex SG21FD3044-161 Software Installation

4

Configure the Netviewer for Network Viewing

The Netviewer allows you to access your DVR/Monitor from a computer in a networking
environment:
•
•
To access the DVR/Monitor from a local or remote network requires you to configure your
Netviewer application:
•
•

4.1 Network Configuration

PROCEDURE
1 Click on the Setup icon
/URL
2 Enter the setup information under the Login tab in the window to setup the cameras for
viewing.
a)
NOTE If your DVR/Monitor is on a network behind a router then you need to forward
your router ports. If you set the port number to 5000 (the default) you need to forward 4
serial ports from the set port number (i.e.:5000, 5001, 5002, and 5003). See APPENDIX
A, page 18.
Local Network Operation (Connected to a Computer on the Local
Network)
Remote Network Operation (Connected to a Computer using the
internet)
NETWORK CONFIGURATION (Page 7)
VIEWING THE CAMERAS (Page 8)
, a SETUP window will appear.
Enter the DVR/Monitor IP address (i.e. 192.168.1.5)
Enter the DVR/Monitor Port (i.e. 5000)
Set the User ID (i.e. admin, Max. 5 digit)
Set the video format (NTSC/PAL).
If you are logged on as Admin User, set the ID and Password
for Admin User and the password for the Guest.
IP
Local Network Viewing only: The IP entry is the IP Address of the
DVR/Monitor. The IP Address of the DVR/Monitor is available by
pressing the "ENTER" key on the remote control
Remote Network Viewing only: The IP entry is the Domain Name
provided when you register with the DDNS service (See APPENDIX A,
page 18).
- 7 -