Advertisement
KI
PH: (269) 382-2050
If these goods are damaged in transit, the DELIVERING TRANSPORTATION
COMPANY is required by law to make notation of damages on the freight bill. If in your
opinion, there may be concealed damage, they are required to make an inspection after goods are
unpacked. Transportation rates are made in proportion to damage. Therefore, the carrier and
NOT the shipper should be charged with any loss or damage. Any claim should be filled with
the delivering TRANSPORTATION COMPANY. PLEASE DO NOT RETURN GOODS
TO US WITHOUT OUR RGA NUMBER AND SHIPPING INSTRUCTIONS.
NOTE: SEE NEXT PAGE FOR RETURN POLICY AND WARRANTY.
READ OPERATING INSTRUCTIONS AND PRECAUTIONS
1. Disconnect power before making any adjustments.
2. Abrasive belt rotation is counter-clockwise. If the abrasive belt is lap spliced be sure of
correct rotation. Butt spliced belts are bi-
directional
3. Belt tension is pre-set with internal spring. No belt
tension adjustment is needed.
4. Belt changing: Disconnect power, squeeze belt
manually, align flip cam to hold tension spring
closed (A), remove belt and install new belt,
move flip cam back to position (B) to tension.
5. Belt tracking: Tracking screw twits yoke to
center belt. With power OFF spin belt manually
to verify belt tracking, adjust tracking screw to
center belt, tighten jam nut to lock tracking
screw. Jog belt with power ON to check belt
centering or "tracking".
6. Always keep the work table within 1/8" of sanding belt. This will avoid pinching material
between sanding belt and platen.
7. Examine the abrasive belt carefully before use. Never use an abrasive belt with a nicked or cut
edge, crease or handing damage.
8. If you are using a dust collector, bags should be emptied frequently during use to maintain
efficiency and prevent buildup of combustible materials.
KALAMAZOO
INDUSTRIES, INC.
KALAMAZOO, MI
www.kalamazooind.com
INSPECTION
BEFORE USING EQUIPMENT
OPERATING INSTRUCTIONS
B
Advertisement
