Table of Contents
Advertisement
Transfers
Optional transfer bars are available. Transfer bars are
designed to make it easier to reposition while seated in the
power chair and to transfer into or out of the power chair.
Refer to the Consumer Safety Guide provided with your
power chair owner's manual for additional information on
transfers. See figure 7.
Controller Position
You can position the controller for either left-hand or right-
hand use. You can also adjust the extension of the controller
from the armrest and the height of the controller.
WARNING!
Use correct tie-down points for controller harness to
prevent the harness from getting caught in the drive
tires, pinched in the seat frame, or damaged when
passing through doorways.
To change the controller position:
1. Turn off the power to the controller.
2. Remove the controller harness from the clips securing it
to the armrest.
3. Loosen the mounting screws in the controller mounting
block. See figure 8.
4. Move the controller mounting block and controller to the
other armrest, tighten the mounting screws, and ensure
the release lever is secure.
BASIC OPERATION INSTRUCTIONS
Figure 7. Transfers
● = Possible Mounting Locations
Figure 8. Controller Position (Standard Mounting Block
Shown)
15
Advertisement
Table of Contents
