Advertisement
TOOL REQUIRED:
J 39200 Digital Multimeter or equivalent
The following bench check may be used to simulate operation on a vehicle. Use the
bench check to verify operation of a CS-144 generator that has been repaired.
1. Mount generator in suitable test stand according to test stand manufacturer's
instructions. Test stand must be capable of driving generator at 6,500 RPM.
Generator Bench Check
2. Make connections as shown in Figure above. Be sure carbon pile is turned off.
Ground polarity of generator and
charged. Use a 30-500 ohm resistor between battery and "L" terminal of
generator.
3. Slowly increase generator speed and observe voltage using J 39200. Important
•
The
battery
•
The engine must be run at 2500 RPM and at ambient temperature.
battery
must be fully charged when making this test.
must be same. Battery must be fully
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Fluke J 39200
Summary of Contents for Fluke J 39200
- Page 1 Battery must be fully charged. Use a 30-500 ohm resistor between battery and "L" terminal of generator. 3. Slowly increase generator speed and observe voltage using J 39200. Important • battery must be fully charged when making this test.
- Page 2 4. If voltage is uncontrolled and increases above 16 volts , repair or replace generator. 5. If voltage is below 16 volts, increase speed and connect and adjust carbon pile to obtain maximum amperage output. Maintain voltage above 13 volts. 6.
Need help?
Do you have a question about the J 39200 and is the answer not in the manual?
Questions and answers