Troubleshooting - Swisher L122-265001 Owner's Manual

Table of Contents

Advertisement

Engine is hard to start or runs erratically. 1. Spark plug w ire loose.
Cylinder rod w ill not extend or contract.
Cylinder rod is slow or erratic w hile
extending and contracting.
Cylinder is leaking.
Engine w ill not turn over.
Engine clicks but w ill not start.
Battery w ill not charge.
NOTE: For repairs beyond those listed here, contact your nearest authorized service center.
* Flushing the reservoir tank and hoses with kerosene whenever service is performed on the tank, hydraulic pump or
valve is recommended. Contact an authorized service center.

TROUBLESHOOTING

2. Blocked fuel line or stale fuel.
3. Water or dirt in fuel system.
4. Dirty air cleaner.
5. Carburetor out of adjustment.
1. Pump coupling system damaged.
3. Low hydraulic fluid.
4. Hydraulic lines blocked.
5. Damaged or broken pump.
6. Damaged control valve.
1. Low hydraulic fluid.
2. Contaminated hydraulic fluid.
3. Excessive pump inlet vacuum.
4. Damaged pump.
5. Damaged control valve.
6. Internal cylinder damage.
1. Broken seals.
2. Scored cylinder.
1. Weak or dead battery.
2. Blow n fuse.
3. Corroded battery terminals.
4. Loose or damaged w iring.
5. Faulty ignition sw itch.
6. Faulty solenoid.
1. Weak or dead battery.
2. Corroded battery terminals.
3. Loose or damaged w iring.
4. Faulty solenoid.
1. Bad battery.
2. Corroded battery terminals.
3. Faulty solenoid.
4. Bad alternator.
17
1. Connect and tighten spark plug w ire.
2. Clean fuel line; fill tank w ith clean, fresh
gasoline
3. Drain fuel tank. Refill w ith fresh
gasoline.
4. Clean or replace air cleaner.
5. See authorized service center.
1. Replace faulty coupler components.
3. Fill hydraulic tank to correct fluid level.
4. Flush and clean hydrualic system.*
5. See authorized service center.
6. See authorized service center.
1. Fill hydraulic tank to correct fluid level.
2. Drain fluid, flush system, and refill.
3. Make certain pump hoses are clear and
unblocked. Make certain hose is not
collapsing under suction.
4. See authorized service center.
5. See authorized service center.
6. See authorized service center.
1. See authorized service center.
2. See authorized service center.
1. Recharge or replace battery.
2. Replace fuse.
3. Clean battery terminals.
4. Check all w iring.
5. Check/replace ignition sw itch.
6. Check/replace solenoid.
1. Recharge or replace battery.
2. Clean battery terminals.
3. Check all w iring.
4. Check/replace solenoid.
1. Replace battery.
2. Clean battery terminals.
3. Check/replace solenoid.
4. See authorized service center.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lsed14534

Table of Contents